1969 Ford F100 with 390, 3 speed with overdrive
We picked the truck up down in Martinsville Va. and brought it back up to NY since rust free F100's of this area are a rarity. The drivetrain is tight just needs a brake job. Starting to take it apart for a paint job which will be my company colors purple and white. Ultimately down the road I am going to make it a dual fuel vehicle where it also runs on Natural Gas.
"If it can't be fixed with a hammer, then it is an electrical problem"
69 Ford F100 Ranger 390 3spd with overdrive
63 Chevy Impala 327 with 4spd. In the family since brand new. Over 280,00 miles
It is all relative, When compared to being from NY the fact it does not have a one foot by one foot hole in the floor is good.
You aint kidding!!!
I'm originally fron the NW PA/SW NY area and my 2001 has no rockerpanels and 10x10 sections ready to fall out of the rear dooe sides and box side panels!!
"Courage is being scared to death, but saddling up anyway." - John Wayne
And From NY....nice lookin (non NY) truck ya got there ....my old company actually wanted me to work at N.Rose ( up near you..I believe)school a few years back
from Indiana! That truck is really sweet. I cant wait to see the paint job. I will be curious to see the conversion to natural gas.
Jeff Penland
70 Ford F100 LWB "Nadine" 302/3 speed with overdrive
If you have to ask you wouldn't understand
"I shall hold the line of right as well as that of glory." English translation of the British Penland coat of arms.
That's a nice looking truck! The lower door area is a common place for rust in our bumps.
You might want to pull the inner door panels off and clean all the debris from the "weep holes" at the bottom of the door, (to make sure the doors aren't holding moisture there).
Jeff http://www.fordification.com/forum/view ... 22&t=46251
SOLD-71 F-350 dually flatbed, 302 / .030 over V-8 with a "baby"C-6, B & M truckshifter, Dana70/4.11 ratio, intermittent wipers, tilt steering, full LED lighting on the flat bed, and no stereo yet (this way I can hear the rattles to diagnose)! SOLD!
Many Ford bumps / one 76' EB / and several dents through the years.
A lot of "oddball" Ford parts collected from working on them for 34 years now!
2008 Ford Escape 4 x 4
from Texas!
